Week 10

The Design Team was able to obtain a T-Valve that would allow the inflation of the two balloons simultaneously. When obtaining this device the Design Team was able to complete the circuit for the Floating Car Project. Below is a video of the mechanism at work. When testing the system the Design Team noticed that there was a leak in the connection between the tube and the balloon. This was due to the fact that the seal created with the electric tape was not laid down properly. After noticing this deification the Design Team corrected it and retested the machine. During the remainder of the week the Design Team focused on finalizing their project so that it would be ready for the final presentation. Now that the team as built all of their part all they need to do is assemble it and adjust any minor errors.

Fully connected circuit attached to balloon testing for inflation

Video of balloon getting inflated from the entire operating system.